國立高雄大學圖資館 |

語系: 繁體中文

說明(常見問題)

圖資館首頁

登入

回首頁

切換: 標籤 | MARC模式 | ISBD

Design of Microwave Front-End Narrow...

Cross, Lee W.

Design of Microwave Front-End Narrowband Filter and Limiter Components.

紀錄類型:	書目-電子資源 : Monograph/item
正題名/作者:	Design of Microwave Front-End Narrowband Filter and Limiter Components.
作者:	Cross, Lee W.
面頁冊數:	101 p.
附註:	Source: Dissertation Abstracts International, Volume: 74-11(E), Section: B.
附註:	Adviser: Vijay K. Devabhaktuni.
Contained By:	Dissertation Abstracts International74-11B(E).
標題:	Engineering, Electronics and Electrical.
電子資源:	http://pqdd.sinica.edu.tw/twdaoapp/servlet/advanced?query=3588122
ISBN:	9781303260353

Design of Microwave Front-End Narrowband Filter and Limiter Components.
Cross, Lee W.

Design of Microwave Front-End Narrowband Filter and Limiter Components. - 101 p.

Source: Dissertation Abstracts International, Volume: 74-11(E), Section: B.

Thesis (Ph.D.)--The University of Toledo, 2013.

This dissertation proposes three novel bandpass filter structures to protect systems exposed to damaging levels of electromagnetic (EM) radiation from intentional and unintentional high-power microwave (HPM) sources. This is of interest because many commercial microwave communications and sensor systems are unprotected from high power levels. Novel technologies to harden front-end components must maintain existing system performance and cost. The proposed concepts all use low-cost printed circuit board (PCB) fabrication to create compact solutions that support high integration.

ISBN: 9781303260353Subjects--Topical Terms:

226981
Engineering, Electronics and Electrical.

Design of Microwave Front-End Narrowband Filter and Limiter Components.
LDR:04040nmm a2200313 4500 001 419311
005 20140520124013.5
008 140717s2013 ||||||||||||||||| ||eng d
020 $a 9781303260353
035 $a (MiAaPQ)AAI3588122
035 $a AAI3588122
040 $a MiAaPQ $c MiAaPQ
100 1 $a Cross, Lee W. $3 660367
245 1 0 $a Design of Microwave Front-End Narrowband Filter and Limiter Components.
300 $a 101 p.
500 $a Source: Dissertation Abstracts International, Volume: 74-11(E), Section: B.
500 $a Adviser: Vijay K. Devabhaktuni.
502 $a Thesis (Ph.D.)--The University of Toledo, 2013.
520 $a This dissertation proposes three novel bandpass filter structures to protect systems exposed to damaging levels of electromagnetic (EM) radiation from intentional and unintentional high-power microwave (HPM) sources. This is of interest because many commercial microwave communications and sensor systems are unprotected from high power levels. Novel technologies to harden front-end components must maintain existing system performance and cost. The proposed concepts all use low-cost printed circuit board (PCB) fabrication to create compact solutions that support high integration.
520 $a The first proposed filter achieves size reduction of 46% using a technology that is suitable for low-loss, narrowband filters that can handle high power levels. This is accomplished by reducing a substrate-integrated waveguide (SIW) loaded evanescent-mode bandpass filter to a half-mode SIW (HMSIW) structure. Demonstrated third-order SIW and HMSIW filters have 1.7 GHz center frequency and 0.2 GHz bandwidth. Simulation and measurements of the filters utilizing combline resonators prove the underlying principles.
520 $a The second proposed device combines a traditional microstrip bent hairpin filter with encapsulated gas plasma elements to create a filter-limiter: a novel narrowband filter with integral HPM limiter behavior. An equivalent circuit model is presented for the ac coupled plasma-shell components used in this dissertation, and parameter values were extracted from measured results and EM simulation. The theory of operation of the proposed filter-limiter was experimentally validated and key predictions were demonstrated including two modes of operation in the on state: a constant output power mode and constant attenuation mode at high power. A third-order filter-limiter with center frequency of 870 MHz was demonstrated. It operates passively from incident microwave energy, and can be primed with an external voltage source to reduce both limiter turn-on threshold power and output power variation during limiting. Limiter functionality has minimal impact on filter size, weight, performance, and cost.
520 $a The third proposed device demonstrates a large-area, light-weight plasma device that interacts with propagating X-band (8-12 GHz) microwave energy. The structure acts as a switchable EM aperture that can be integrated into a radome structure that shields enclosed antenna(s) from incident energy. Active elements are plasma-shells that are electrically excited by frequency selective surfaces (FSS) that are transparent to the frequency band of interest. The result is equivalent to large-area free-space plasma confined in a discrete layer. A novel structure was designed with the aid of full-wave simulation and was fabricated as a 76.2 mm square array. Transmission performance was tested across different drive voltages and incidence angles. Switchable attenuation of 7 dB was measured across the passband when driven with 1400 Vpp at 1 MHz. Plasma electron density was estimated to be 3.6 x 10 12 cm-3 from theory and full-wave simulation. The proposed structure has potential for use on mobile platforms.
590 $a School code: 0232.
650 4 $a Engineering, Electronics and Electrical. $3 226981
650 4 $a Physics, Electricity and Magnetism. $3 227483
690 $a 0544
690 $a 0607
710 2 $a The University of Toledo. $b Engineering. $3 660368
773 0 $t Dissertation Abstracts International $g 74-11B(E).
790 $a 0232
791 $a Ph.D.
792 $a 2013
793 $a English
856 4 0 $u http://pqdd.sinica.edu.tw/twdaoapp/servlet/advanced?query=3588122

筆 0 讀者評論

多媒體

多媒體檔案
http://pqdd.sinica.edu.tw/twdaoapp/servlet/advanced?query=3588122

評論

新增評論分享你的心得

Export

取書館別